Toyota Corolla (E170): Engine compartment

1 Washer fluid tank

1 Washer fluid tank
2 Engine oil filler cap
3 Engine oil level dipstick 4 Brake fluid reservoir
5 Battery
6 Fuse box
7 Electric cooling fan
8 Engine coolant reservoir 9 Condenser
10 Radiator

Share this page:

Other materials:

How to proceed with troubleshooting
The hand–held tester can be used at step 3, 4, 6, 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Connect the obd ii scan tool or hand–held tester to dlc3 4 Check and clear dtc and freeze frame data 5 Visual inspection 6 Setting the check mode diagnosis 7 Proble ...

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Replacement
1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...