Toyota Corolla (E170): Washer fluid
Add washer fluid in the following situations:
● A washer does not work.
● Vehicles without a multi-information display: The low windshield washer fluid warning light (if equipped) comes on.
● Vehicles with a multi-information display: The warning message (if equipped) appears
on the multi-information display.
CAUTION
■When adding washer fluid
Do not add washer fluid when the engine is hot or running as washer fluid contains alcohol and may catch fire if spilled on the engine etc.
NOTICE
■Do not use any fluid other than washer fluid
Do not use soapy water or engine antifreeze instead of washer fluid.
Doing so may cause streaking on the vehicle’s painted surfaces.
■Diluting washer fluid
Dilute washer fluid with water as necessary.
Refer to the freezing temperatures listed on the label of the washer fluid bottle.
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...
Pre–check
1. Diagnosis system
Release the parking brake lever.
check the warning lights.
When the ignition switch is turned on, check that the abs
warning light and brake warning light goes on for 3 sec.
Hint:
when the parking brake is applied or the level of the brake
fluid is low, the ...
Replacement
1. Remove combination meter assembly
2. Disconnect brake master cylinder push rod clevis
remove the clip and push rod clevis pin and wave washer, and
disconnect the push rod clevis from
the brake pedal.
3. Remove brake pedal support sub–assy
Remove the bolt from the bra ...