Toyota Corolla (E120) 2002–2008 Repair Manual / Power steering / Rack & pinion power steering gear assy

Toyota Corolla (E120): Rack & pinion power steering gear assy

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Inspection procedure
1 Check operation(overdrive) Drive the vehicle after the engine warms up.  check that overdrive on e off occurs by an operation of the o/d switch on–off. 2 Inspect terminal voltage(od) Remove the cruise control ecu assy with the connector still connected.  tur ...

Inspection procedure
Hint Advanced timing over (valve timing is out of specified range) P0011 Retarded timing over (valve timing is out of specified range) P0012 If dtc p0011 or p0012 is displayed, check the vvt system circuit. Read freeze frame data using the hand–held tester o ...