Toyota Corolla Repair Manual: Open circuit in stop light switch circuit

Inspection procedure

1 Inspect fuse(ecu–ig fuse) Remove ecu–ig fuse from the instrument panel j/b.  check continuity of ecu–ig fuse. Ok: continuity 2 Inspect battery Ok: voltage: 10 – 14 v ...

Circuit description

Wiring diagram ...

Other materials:

Transmitter battery
Replacement 1. Replace transmitter battery Notice: special caution should be taken for handling each component as they are precision electronic components. Using a screwdriver, pry out the transmitter case. Notice: do not forcibly pry out the case. Hint: tape the screwdriver tip ...

Inside vehicle
General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not required ...

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Perform active test using the hand–held tester (a ...