Toyota Tacoma manuals

Toyota Corolla Repair Manual: Only wireless control function does not operate (prepare new or normal transmitter of the same type vehicle)

Toyota Corolla Repair Manual / Diagnostics / Wireless door lock control system / Only wireless control function does not operate (prepare new or normal transmitter of the same type vehicle)

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown ...

Circuit description
The door control receiver receives a signal from the transmitter and sends this signal to the integration relay. Then, the integration relay controls door operation by sending a door lock/unloc ...

Other materials:

For vehicles equipped with srs airbag and seat belt pretensioner
Hint: the vehicle is equipped with an srs (supplemental restraint system), such as the horn button assembly, the instrument panel passenger airbag assembly, the front seat airbag assembly, the center airbag sensor assembly, the front airbag sensor, the side airbag sensor and the seat belt p ...

Precaution
1. Check that the battery cables are connected to the correct terminals. 2. Disconnect the battery cables when the battery is given a quick charge. 3. Do not perform tests with a high voltage insulation resistance tester. 4. Never disconnect the battery while the engine is running. 5. Check that ...

Circuit description
Refer to dtc p0130 Hint: the ecm provides a pulse width modulated control circuit to adjust current through the heater. The heated oxygen sensor heater circuit uses a relay on the b+ side of the circuit. Monitor description The ecm uses the heated oxygen sensor information to regulate t ...

© 2011-2023 Copyright www.tcorolla.net