Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Wireless door lock control system
Toyota Corolla (E120): Wireless door lock control system
- How to proceed with troubleshooting
- Terminals of ecu
- Only wireless control function does not operate (prepare new or normal transmitter of the same type vehicle)
Other materials:
Inspection procedure
1 Inspect fuse(ecu–ig fuse)
Remove ecu–ig fuse from the instrument panel j/b.
check continuity of ecu–ig fuse.
Ok:
continuity
2 Inspect battery
Ok:
voltage: 10 – 14 v
3 Inspect skid control ecu connector(ig1 terminal voltage)
In case of using hand–held te ...
Terminals of ecu
1. Inspect integration relay
Disconnect the connector from the integration relay.
check the continuity between each terminal of the disconnected connector
and the body ground, as
shown in the illustration and table.
Standard:
If the result is not as specified, the vehicle’s ...
Dtc check/clear
1. Dtc check (normal mode)
Notice:
hand–held tester only:
when the diagnostic system is switched from the normal
mode to the check mode, all the dtcs and freeze frame
data recorded in the normal mode will be erased. So before
switching modes, always check the dtcs and freeze frame
data, and ...


