Toyota Corolla (E120) 2002–2008 Repair Manual / Lighting / Center stop lamp assy
Toyota Corolla (E120): Center stop lamp assy
Replacement
1. Remove package tray trim panel assy (w/o rear spoiler)
2. Remove center stop lamp assy (w/o rear spoiler)

- Remove the center stop light assy as shown in the illustlation.
3. Remove center stop lamp assy (w/ rear spoiler)

- Remove the 2 screws.
- disconnect the connector and remove the center stop light assy.
Other materials:
Circuit description
Refer to dtc p0130
Dtc no
Dtc detection condition
Trouble area
P0136
The following condition (a) or (b) continues for 300 seconds or
more:
During driving with the engine warmed up, heated oxygen
sensor o tp t does not change
output change.
he ...
On–vehicle inspection
1. Inspection throttle body idle speed control valve assy
Notice:
it is impossible to check the resister value and the operation
of isc valve by itself, because the isc valve
has an ic circuit inside it, which transforms the duty
signal from the ecm to the derive signal.
After check ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Perform active test by hand–held tester(abs warning light)
Check that ”on” and ”off” of the abs warning light can be shown on the
...


