Toyota Corolla (E120): Rear door belt moulding assy lh

Replacement

Hint

:

  • the installation procedures are the removal procedures in reverse order.
  • Use the same procedures for the rh side and lh side.

1. Remove rear armrest assy lh

2. Remove power window regulator switch assy rear (w/ power window)

3. Remove rear door window regulator handle assy (w/o power window)

4. Remove rear door trim board sub–assy lh

5. Remove rear door belt moulding assy lh

  1. Put protective tape under the weatherstrip.
  2.  using a moulding remover, pry out the weatherstrip as shown in the illustration.

Hint

: tape the moulding remover tip before use.

    Share this page:

    Other materials:

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...

    Problem symptoms table
    Hint: use the table below to help determine the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts. 1. Headlamp and tail lamp 2. Front fog lamp system 3. Turn signal and hazard warni ...

    Inspection procedure
    1 Inspect stop lamp switch assy Check that the stop light lights up when brake pedal is depressed and turns off when the brake pedal is released. 2 Inspect skid control ecu terminal voltage(stp terminal) Disconnect skid control ecu connector. measure voltage between termina ...