Toyota Corolla (E210): Content of driving information

■ Display items

  • Fuel economy
  • Eco Driving Indicator/Driving range

■ Fuel economy

Use the displayed values as a reference only.

  1. Current fuel consumption

Displays instantaneous current fuel consumption.

  1. Average fuel economy (after reset)

To reset the average fuel economy display, press and hold the meter control switch. meter control switch.

The average fuel economy display can be changed in .

  • Average fuel economy (after start)

Displays the average fuel consumption since engine start.

  • Average fuel economy (after refuel)

Displays the average fuel consumption since the vehicle was refueled.

■ Eco Driving Indicator/Driving range

  • Eco Driving Indicator

  1. Eco Driving Indicator Light

During Eco-friendly acceleration (Eco driving), the Eco Driving Indicator Light will turn on. When the acceleration exceeds the Zone of Eco driving, or when the vehicle is stopped, the light turns off.

  1. Eco Driving Indicator Zone Display

Suggests the Zone of Eco driving with current Eco driving ratio based on acceleration.

  1. Eco driving ratio based on acceleration

If the acceleration exceeds the Zone of Eco driving, the right side of the Eco Driving Indicator Zone Display will illuminate.

At this time, the Eco Driving Indicator Light will turn off.

  1. Zone of Eco driving
  • Driving range

Displays driving range with remaining fuel. Use the displayed values as a reference only.

This distance is computed based on your average fuel consumption.

As a result, the actual distance that can be driven may differ from that displayed.

When only a small amount of fuel is added to the tank, the display may not be updated.

When refueling, turn the engine switch off. If the vehicle is refueled without turning the engine switch off, the display may not be updated.

■Eco Driving Indicator

Eco Driving Indicator will not operate under the following conditions:

  • The shift lever is in any position other than D.
  • The driving mode is set to Sport mode.
  • The vehicle speed is approximately 80 mph (130 km/h) or higher.
    Share this page:

    Other materials:

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

    Replacement
    Hint: components: 1. Table of bolt, screw and nut Notice: be sure to tape the tip of the screwdriver when using it to disengage the meshing of the clips and claws. Hint: indicate the bolts, screws and nuts, which are necessary for installation and removal of the instrument panel, in th ...

    Using the steering wheel switches
    The steering wheel switches can be used to operate a connected cellular phone or portable digital audio player (portable player). Operating a Bluetooth® phone using the steering wheel switches 1 Volume The voice guidance volume cannot be adjusted using these buttons. 2 Off-hook switch Turns ...