Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / Brake switch ”b” circuit high / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect stop lamp switch assy


2 Check harness and connector(stop lamp switch assy – ecm)
- Install the stop lamp switch assy.
- disconnect the ecm connector.
- measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
Standard:



Replace ecm
Other materials:
Positioning a floor jack
When using a floor jack, follow the instructions in the manual provided with
the jack and perform the operation safely.
When raising your vehicle with a floor jack, position the jack correctly.
Improper placement may damage your vehicle or cause injury.
◆ Front
◆ Rear
1 Take out ...
Overhaul
1. Precaution
2. Disconnect battery negative terminal
3. Inspect place front wheels facing straight ahead
4. Remove horn button assy
Notice:
if the airbag connector is disconnected with the ignition
switch being at on, dtcs will be recorded.
using a torx socket wrench, loosen the ...
Automatic transaxle fluid (atm)
On–vehicle inspection
1. Check the fluid level
Hint:
drive the vehicle so that the engine and transaxle are at normal
operating temperature.
Fluid temperature: 70 – 80 °c (158 – 176 °f)
park the vehicle on a level surface and set the parking
brake.
with the engin ...


