Toyota Corolla (E170): Operating the touch screen

By touching the screen with your finger, you can control the multimedia system, etc.

■ Drag*

Touch the screen with your finger, and move the screen to the desired position.

● Scrolling the lists ● Using scroll bar in lists

■ Flick*

Touch the screen with your finger and quickly move the screen by flicking your finger.

● Scrolling the main screen page ● Returning to the menu screen from the sub-menu screen (screen one level below)

*: The above operations may not be performed on all screens.

■When using the touch screen

●If the screen is cold, the display may be dark, or the system may seem to be operating slightly slower than normal.

●The screen may seem dark and hard to see when viewed through sunglasses.

Change your angle of viewing, adjust the display on the “Display Settings” screen  or remove your sunglasses.

NOTICE

■To avoid damaging the touch screen

●To prevent damaging the screen, lightly touch the screen buttons with your finger.

●Do not use objects other than your finger to touch the screen.

●Wipe off fingerprints using a glass cleaning cloth. Do not use chemical cleaners to clean the screen, as they may damage the touch screen.

    Share this page:

    Other materials:

    Circuit description
    Shifting from 1st to o/d is performed in combination with on and off of the shift solenoid valve s1 and s2 controlled by ecm. If an open or short circuit occurs in either of the solenoid valves, the ecm controls the remaining normal solenoid valve to allow the vehicle to be operated smoothly ...

    Front wheel alignment
    Adjustment 1. Inspect tire 2. Measure vehicle height Vehicle height: Measuring points: a: ground clearance of front wheel center b: ground clearance of lower suspension arm front bolt center c: ground clearance of axle beam set bolt center d: ground clearance of rear wheel center Not ...

    Changing engine switch modes
    Modes can be changed by pressing the engine switch with brake pedal released. (The mode changes each time the switch is pressed.) OFF*1 The emergency flashers can be used. ACC*2 Some electrical components such as the audio system can be used. "ACCESSORY" will be displayed on the multi-info ...