Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Ts terminal circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
- Turn the ignition switch to on.
- measure voltage between terminals ts and cg of dlc3.
Ok: voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
- Check for open and short circuit in harness and connector between terminal cg of the dlc3 and body ground
3 Check harness and connector(skid control ecu – dlc3)
- Check for open and short circuit in harness and connector between terminal ts of the dlc3 and skid control ecu
Check and replace brake actuator assy
Other materials:
Inspection procedure
1 Check relay (marking: starter cut)
Inspect the relay continuity, as shown in the illustration
and table.
Standard:
2 Check tvip ecu
Disconnect the tvip ecu connector.
turn the ignition switch position to the start.
measure the voltage between the termina ...
Correct driving posture
1 Adjust the angle of the seatback so that you are sitting straight up and so
that you do not have to lean forward to steer.
2 Adjust the seat so that you can depress the pedals fully and so that your arms
bend slightly at the elbow when gripping the steering wheel.
3 Lock the head restraint ...
Circuit description
Shifting from 1st to o/d is performed in combination with on and off of the
shift solenoid valve s1 and s2
controlled by ecm. If an open or short circuit occurs in either of the solenoid
valves, the ecm controls the
remaining normal solenoid valve to allow the vehicle to be operated smoothly
...