Toyota Corolla (E120): Ts terminal circuit

Share this page:

Other materials:

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

The ambient temperature does not display
Wiring diagram Inspection procedure 1 Inspect outer ambient temperature sensor Remove cooler (ambient temp. Sensor) thermistor.  measure resistance between terminals 1 and 2 of cooler (ambient temp. Sensor) thermistor connector at each temperature. Resistance: at 0 c (0 f) ...

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...