Toyota Corolla (E210): Pictorial index

Share this page:

Other materials:

Inspection
1. Headlamp dimmer switch assy Inspect light control switch continuity.  Measure the resistance according to the value(s) in the table below. Standard: Inspect headlight dimmer switch continuity.  Measure the resistance according to the value(s) in the tabl ...

Inspection procedure
1 Check harness and connector(transmission control switch – body ground) Disconnect the transmission control switch connector of shift lever assy. measure the resistance according to the value(s) in the table below. Standard: 2 Inspect transmission control switch M ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...