Toyota Corolla (E170): Head restraints

Head restraints are provided for all seats.

Share this page:

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Overhaul
Hint: components: 1. Remove front wheel 2. Disconnect front stabilizer link assy lh Remove the nut and disconnect the front stabilizer link assy lh from the shock absorber assy front lh. Hint: if the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the st ...

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...