Toyota Corolla (E170): For safety drive

For safe driving, adjust the seat and mirror to an appropriate position before driving.

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

Inspection procedure


Hand–held tester: 1 Check operation of stop light Check if the stop lights go on and off normally when the brake pedal is depressed and released. 2 Inspect stop light switch assy Check the resistance between the terminals when the switch is turned on and off. Standard: ...

Thermostat
Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...