Toyota Corolla (E120) 2002–2008 Repair Manual / Introduction / How to troubleshoot ecu controlled
systems / Electronic circuit inspection procedure
Toyota Corolla (E120): Electronic circuit inspection procedure
Other materials:
Adjustment
1. Remove rear wheel
2. Adjust rear drum brake shoe clearance
3. Install rear wheel
torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
4. Inspect parking brake lever travel
pull the parking brake lever to the fully applied position, and
count the number of clicks.
Parking brake lever tr ...
Speed sensor front lh
Replacement
Hint:
replace the rh side by the same procedure as the lh side.
1. Remove front wheel
2. Remove front fender liner lh
3. Remove speed sensor front lh
Disconnect the speed sensor wire harness clamp from
the body.
disconnect the speed sensor connector.
Remo ...
Inspection procedure
1 Inspect shift solenoid valve(sl)
Remove the shift solenoid valve sl.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) battery lead to the solenoid connector
terminal, and the negative (–) battery lead to the
so ...