Toyota Corolla (E210) 2019-2026 Owners Manual / Driving / Using the driving support systems / Driving mode select switch
Toyota Corolla (E210): Driving mode select switch
The driving modes can be selected to suit driving condition.
Selecting a drive mode

Operate the driving mode select switch forward or backward to select the desired driving mode on the multi-information display.
- Normal mode
Provides an optimal balance of fuel economy, quietness, and dynamic performance. Suitable for normal driving.
- Sport mode
Controls the transmission and engine to provide quick, powerful acceleration. This mode also changes the steering feel, making it suitable for when agile driving response is desired, such as when driving on roads with many curves.
When the sport mode is selected, sport mode indicator comes on.
- Eco drive mode
Helps the driver accelerate in an eco-friendly manner and improve fuel economy through moderate throttle characteristics and by controlling the operation of the air conditioning system (heating/cooling).
When the eco mode is selected, eco drive mode indicator comes on.
■Operation of the air conditioning system in Eco drive mode
Eco drive mode controls the heating/ cooling operations and fan speed of the air conditioning system to enhance fuel efficiency. To improve air conditioning performance, perform the following operations:
- Turn off eco air conditioning mode
- Adjust the fan speed
- Turn off Eco drive mode
■Automatic deactivation of sport mode
If the engine switch is turned off after driving in sport mode, the drive mode will be changed to normal mode.
Other materials:
Terminals of ecu
Oscilloscope wave (*1)
Hint:
terminal: od – gnd
gauge set: 5 v / div, 50 ms / div
condition: during cruise control driving o/d switch on.
...
Circuit description
Refer to dtc p0130
Dtc no
Dtc detection condition
Trouble area
P0136
The following condition (a) or (b) continues for 300 seconds or
more:
During driving with the engine warmed up, heated oxygen
sensor o tp t does not change
output change.
he ...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...


