Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Crankshaft position sensor ”a” circuit

Toyota Corolla (E120): Crankshaft position sensor ”a” circuit

Dtc p0335 crankshaft position sensor ”a” circuit

Dtc p0339 crankshaft position sensor ”a” circuit intermittent

Share this page:

Other materials:

Air outlet layout and operations
■ Location of air outlets The air outlets and air volume changes according to the selected air flow mode. :If equipped ■ Adjusting the position of and opening and closing the air outlets Front center Direct air flow to the left or right, up or down Front right-hand side Direct air flow to th ...

Inspection procedure
1 Inspect cruise control actuator assy Inspect the cruise control actuator arm locking operation.  Turn the ignition switch to off.  Disconnect the cruise control actuator assy connector.  Connect the positive (+) lead from the battery to the terminal 3 (l) of crui ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...