Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Short in p squib (2nd step) circuit / Circuit description
Toyota Corolla (E120): Circuit description
The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b1185/57 is recorded when a short is detected in the p squib (2nd step) circuit.
Wiring diagram
Other materials:
Inspection procedure
1 Check airbag sensor assy center connector
Disconnect negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
check the connection of the airbag sensor assy center connectors.
2 Check air bag sensor assy center
Sst 09843–18040
Connect the n ...
Inspection procedure
Hint:
hand–held tester only:
narrowing down the trouble area is possible by performing ”a/f control” active
test (heated oxygen
sensor or other trouble areas can be distinguished).
perform active test using hand–held tester (a/f control).
Hint:
”a/f control” is the act ...
Removal and installation of engine intake parts
If any metal tip is mixed in the inlet pass, this may give a
bad effect to the engine and turbocharger.
when removing and installing the inlet system parts,
close the opening of the removed inlet system parts and
the engine with a clean shop rag or gummed tape.
when inst ...