Toyota Corolla (E120): Circuit description
The p/t squib (rh) circuit consists of the airbag sensor assy center and seat belt pretensioner (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0132/61 is recorded when a ground short is detected in the p/t squib (rh) circuit.
Wiring diagram
Other materials:
Inspection
1. Fuel injector assy
Inspect injector resistance.
Using an ohmmeter,measure the resistance between
the terminals.
Resistance: 13.4 – 14.2 Ω at 20 c (68 f)
Inspect injector inspection
Caution:
keep injector clear of sparks during the test.
Purch ...
Problem symptoms table
Hint:
use the table below to help determine the cause of the problem. The numbers
indicate the priority of the
likely cause of the problem. Check each part in order. If necessary, replace
these parts.
1. Headlamp and tail lamp
2. Front fog lamp system
3. Turn signal and hazard warni ...
Vehicle control system
Ignition or starter switch assy
Replacement
1. Remove steering column cover
2. Remove ignition or starter switch assy
Disconnect the ignition switch connector and unlock
warning switch connector.
remove the 2 clamps.
remove the 2 screws and ignition switch.
Inspectio ...