Toyota Corolla (E120): Circuit description

This relay supplies power to each abs solenoid. After the ignition switch is turned on, if the initial check is ok, the relay goes on

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

    Engine immobilizer system
    The vehicle's keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle's on-board computer. Never leave the keys inside the vehicle when you leave the vehicle. This system is designed to help prevent vehicle theft but doe ...

    Inspection procedure
    Hint: if dtcs p0115, p0116, p0117, p0118 and p0125 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform the troubleshooting of dtc p0115, p0117 or p0118 first. Read freeze frame data using the hand-held tester or the obd ii scan to ...