Toyota Corolla (E210): Outside rear view mirrors

The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view.

■When using the outside rear view mirrors in a cold weather

When it is cold and the outside rear view mirrors are frozen, it may not be possible to fold/extend them or adjust the mirror surface. Remove the ice, snow, etc. covering the outside rear view mirrors.

WARNING

■Important points while driving

Observe the following precautions while driving.

Failure to do so may result in loss of control of the vehicle and cause an accident, resulting in death or serious injury.

  • Do not adjust the mirrors while driving.
  • Do not drive with the mirrors folded.
  • Both the driver and passenger side mirrors must be extended and properly adjusted before driving.

Adjustment procedure

1. To select a mirror to adjust, turn the switch.

  1. Left
  2. Right

2. To adjust the mirror, operate the switch.

  1. Up
  2. Right
  3. Down
  4. Left

■Mirror angle can be adjusted when

The engine switch is in ACC or ON.

■When the mirrors are fogged up (vehicles with outside rear view mirror defoggers)

The outside rear view mirrors can be cleared using the mirror defoggers.

Turn on the rear window defogger to turn on the outside rear view mirror defoggers.

WARNING

■When the mirror defoggers are operating (vehicles with outside rear view mirror defoggers)

Do not touch the rear view mirror surfaces, as they can become very hot and burn you.

Folding the mirrors

Push the mirror back in the direction of the vehicle's rear.

WARNING

WARNING

■When a mirror is moving

To avoid personal injury and mirror malfunction, be careful not to get your hand caught by the moving mirror.

    Share this page:

    Other materials:

    Safe Exit Assist
    The safe exit assist is a system that uses rear side radar sensors installed on the inner side of the rear bumper to help occupants judge if an approaching vehicle or bicycle may collide with a door when opening it or cancel opening of the door, to reduce the possibility of a collision. WARNING ■C ...

    Indicators
    The indicators inform the driver of the operating state of the vehicle’s various systems. *1: Vehicles without a smart key system: These lights turn on when the engine switch is turned to the “ON” position to indicate that a system check is being performed. They will turn off after the ...

    Check and replace ecu
    Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...