The p/t squib (rh) circuit consists of the airbag sensor assy center and seat belt pretensioner (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0130/63 is recorded when a short is detected in the p/t squib (rh) circuit.
Wiring diagram
Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage)
Disconnect the skid control ecu connector.
measure the voltage between terminals +bs (2) and gnd
(1, 23) of skid control ecu harness side connector.
Voltage: 10 – 14 v
2 Reconfirm dtc
Check the dtc .
Ok :
n ...
Shifting the shift lever
Vehicles without a smart key system:
While the engine switch is in the “ON” position, depress the brake pedal and
move the shift lever.
Vehicles with a smart key system: While the engine switch is in IGNITION ON mode,
depress the brake pedal and move the shift lever.
When shifting the shif ...
Diagnostic trouble code chart
The inspection procedures are shown in the table below. This table allows
efficient and accurate troubleshooting
using the diagnostic trouble codes displayed in the diagnostic trouble code
chart. Proceed with
troubleshooting in accordance with the inspection procedures listed in the
diagnost ...