Toyota Corolla (E120) 2002–2008 Repair Manual / Drive shaft / propeller shaft
Toyota Corolla (E120): Drive shaft / propeller shaft
- Drive shaft, propeller shaft, axle
- Front drive shaft
- Front axle hub sub–assy lh
- Front axle lh hub bolt
- Rear axle hub & bearing assy lh
- Rear axle lh hub bolt
Other materials:
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and rele ...
Circuit description
The speed sensor detects wheel speed and transmits the appropriate
signals to the ecu. These signals are used for control
of the abs control system. Each of the front and rear rotors has
48 serrations.
When the rotors rotate, the magnetic field generated by the permanent
magnet in the spe ...
Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu
assy. The cruise control ecu
assy uses this signal to correct the discrepancy between the throttle valve
position and the actuator position
sensor values to enable accurate cruise control at the set speed. If the idl ...


