Toyota Corolla (E120) 2002–2008 Repair Manual / Drive shaft / propeller shaft / Rear axle hub & bearing assy lh
Toyota Corolla (E120): Rear axle hub & bearing assy lh
Other materials:
Adjustment
1. Inspect and adjust clutch pedal sub–assy
Turn over the floor carpet.
check that the pedal height is correct.
Pedal height from asphalt sheet:
135.8 – 145.8 Mm (5.346 – 5.740 In.)
adjust the pedal height.
Loosen the lock nut and turn the stopper bolt until
...
Confirmation driving pattern
Connect the hand–held tester or the obd ii scan tool to the dlc3.
record dtcs and the freeze frame data.
set the check mode using the hand–held tester .
read the value on the misfire counter for each cylinder when
idling. If the value is displayed on the
misfire c ...
Valve clearance
Adjustment
1. Remove cylinder head cover no.2
Remove the 2 nuts, 2 clips and cylinder head cover.
2. Disconnect engine wire
Remove the 5 clamps from the 5 clamp brackets.
Disconnect the 4 ignition coil connectors.
Remove the bolt and nut installing the engine wire ...


