Toyota Corolla (E120): Wiper & washer

Share this page:

Other materials:

Inspection procedure
Hint: if different dtcs related to different systems that have terminal e2 as the ground terminal are output simultaneously, terminal e2 may be open. If dtc p0441 (purge flow), p0446 (vsv for ccv), p0451, p0452 or p0453 (evaporative pressure sensor) is output with dtc p0442 or p0456, ...

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

Inspection procedure
1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...