Toyota Corolla (E120): Washer nozzle

Adjustment

1. Inspect washer nozzle

  1.  with the engine running, check that the point where the washer fluid hits the windshield and the rear window is within the range indicated by the hatched line.

Audio & visual

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Check battery electrolyte level Check the electrolyte quantity of each cell (maintenance–free battery).  If under the lower level, replace the battery (or add distilled water if possible) and check the charging system.  check the electrolyte quantity of each cell ...

    Inspection procedure
    1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

    Inspection procedure
    1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...