Toyota Corolla (E170): Vehicle interior

Vehicle exterior

    Share this page:

    Other materials:

    Cruise control actuator assy
    Replacement 1. Remove cruise control actuator cover Disengage the 2 claws, then remove the cruise control actuator cover. 2. Separate accelerator control cable assy Loosen the double nut and separate the accelerator control cable assy. 3. Separate accelerator auto drive ca ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Adjustment
    1. Check and adjust brake pedal height Inspect brake pedal height. Pedal height from asphalt sheet: m/t: 134.9 – 144.9 Mm (5.311 – 5.703 In.) A/t: 136.0 – 146.0 Mm (5.353 – 5.747 In.)  Disconnect the connector from the stop lamp switch.  Remove the stop lamp ...