Toyota Corolla (E170): General maintenance

Listed below are the general maintenance items that should be performed at the intervals specified in the “Owner’s Warranty Information Booklet” or “Owner’s Manual Supplement/Scheduled Maintenance Guide”. It is recommended that any problem you notice should be brought to the attention of your Toyota dealer or qualified service shop for advice.

Share this page:

Other materials:

Problem symptoms table
Hint: proceed with troubleshooting of each circuit in the table below. Symptom Suspect area When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.  Srs warning light ci ...

Overhaul
1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...

How to proceed with troubleshooting
The hand–held tester can be used at step 3, 4, 6, 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Connect the obd ii scan tool or hand–held tester to dlc3 4 Check and clear dtc and freeze frame data 5 Visual inspection 6 Setting the check mode diagnosis 7 Proble ...