Toyota Corolla (E120): Transmission wire (atm)

Replacement

1. Remove transmission valve body assy

2. Remove transmission wire

  1. Disconnect the transmission wire connector.
  2.  removal the bolt and transmission wire.

3. Install transmission wire

  1. Coat a o–ring with atf.
  2.  install the transmission wire and bolt.

    Torque: 5.4 Nvm (55 Kgf·cm, 48 in.Vlbf)

  3.  connect the transmission wire connector.

4. Install transmission valve body assy

    Share this page:

    Other materials:

    Circuit description
    The park/neutral position switch detects the shift lever position and sends signals to the ecm. Monitor description The park/neutral position switch detects the gearshift position and sends a signal to the ecm. For security, the park/neutral position switch detects the gearshift positio ...

    Diagnostic trouble code chart
    Notice: when removing the part, turn the ignition switch to off. Hint: using sst 09843–18040, it connect the terminal tc and cg of dlc3. If any abnormality is not found when inspecting parts, inspect the ecu and ground points for poor contact. If a malfunction code is displayed during ...

    Hood
    Release the lock from the inside of the vehicle to open the hood. 1 Pull the hood lock release lever. The hood will pop up slightly. 2 Pull up the auxiliary catch lever and lift the hood. 3 Hold the hood open by inserting the support rod into the slot. CAUTION ■Pre-driving check C ...