Toyota Corolla Repair Manual: Torque converter clutch solenoid circuit low/high
Dtc p2769 torque converter clutch solenoid circuit low (shift solenoid valve sl)
Dtc p2770 torque converter clutch solenoid circuit high (shift solenoid valve sl)
Inspection procedure
1 Inspect transmission wire(slt)
Disconnect the transmission wire connector from the
transaxle.
measure the resistance according to the value(s) in the
table below.
Standard:
Me ...
Circuit description
The shift solenoid valve sl is turned ”on” and ”off” by signals from the ecm
in order to control the hydraulic
pressure operation, the lock–up relay valve, which then the controls operation
of th ...
Other materials:
Inside vehicle
General maintenance
Performing these maintenance checks on the vehicle in the owner’s
responsibility. The owner may
perform the maintenance or take the vehicle to a service center.
Check the parts of the vehicle described below on a daily basis. In most cases,
special tool are not
required ...
Circuit description
Refer to dtc c0200/31, c0205/32, c1235/35, c1236/36
Hint:
Dtc no. C0210/33, c1238/38 is for the right rear speed sensor.
Dtc no. C0215/34, c1239/39 is for the left rear speed sensor.
Wiring diagram
...
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and releas ...