Toyota Corolla (E170): Tire inflation pressure

The recommended cold tire inflation pressure and tire size are displayed on the tire and loading information label.

Inspection and adjustment procedure

    Share this page:

    Other materials:

    Circuit description
    The door key lock and unlock switch is built in the door lock motor. Wiring diagram Inspection procedure 1 Check door lock 2 Check wire harness (tvip ecu  door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the t ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...