Toyota Corolla (E120): Terminals of ecu

Oscilloscope wave (*1)

Oscilloscope wave (*1)

Hint

:

  • terminal: od – gnd
  • gauge set: 5 v / div, 50 ms / div
  • condition: during cruise control driving o/d switch on.
    Share this page:

    Other materials:

    Antenna cord sub–assy
    Replacement Hint: components: 1. Remove instrument panel sub–assy upper Hint: refer to the procedure until the step, ”remove instrument panel sub–assy upper” of instrument panel sub–assy lower. Remove the related parts as long as the antenna cord sub–assy can be removed ...

    Replacement
    Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire (w/ abs) 4. Remove rear axle hub & bearing assy lh Remove the 4 bolts and hub & bearing assy lh. 5. Install rear axle hub & bearing assy lh Install t ...

    Noise occurs
    Inspection procedure 1 Check of speaker installation Check speaker installation condition.  Check that each speaker is securely installed. Standard: malfunction disappear. Hint: the radio is equipped with noise prevention system that does not work against the regular use of t ...