Toyota Corolla (E120): Stabilizer bar rear

Replacement

Hint

: components:

1. Remove stabilizer bar rear

  1. Remove the 2 bolts, nuts and stabilizer bar.

2. Install stabilizer bar rear

  1. Install the 2 bolts, nuts and stabilizer bar.

    Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf)

H

int

: install the stabilizer bar so that the mark is positioned onthe rear right side of the vehicle.

    Share this page:

    Other materials:

    Warning lights
    Warning lights inform the driver of malfunctions in the indicated vehicle’s systems. *1: Vehicles without a smart key system: These lights turn on when the engine switch is turned to the “ON” position to indicate that a system check is being performed. They will turn off after the engi ...

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Switches
    Instrument panel light control dial Automatic High Beam switch Heated steering wheel switch* Windshield wiper de-icer switch* Outside rear view mirror switch Door lock switches Power window switches Window lock switch *: If equipped Meter control switches Paddle shift switches*1 C ...