Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Srs warning light circuit malfunction (does not light up, when ignition switch is turned to on)

Toyota Corolla (E120): Srs warning light circuit malfunction (does not light up, when ignition switch is turned to on)

Share this page:

Other materials:

Rear axle beam assy
Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove luggage compartment door cover 2. Remove rear spoiler  remove the 2 screws.  disconnect the wire harness connector.  put protective tape. &nb ...

Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...