Toyota Corolla (E120): Circuit description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light lights up for approx. 6 Seconds after the ignition switch is turned from the lock position to on position, and then turns off automatically.
If there is a malfunction is the srs, the srs warning light lights up to inform the driver of the abnormality.
When terminals tc and cg of the dlc3 are connected, the dtc is displayed by blinking the srs warning light.
Wiring diagram
Srs warning light circuit malfunction (does not light
up, when ignition switch is turned to on)
Other materials:
Emergency flashers
The emergency flashers are used to warn other drivers when the vehicle has
to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once again.
■Emergency flashers
If the emergency flashers are used ...
Foamed material application areas
If an increase in temperature or other condition damages the foamed material
when repairing or replacing the panel,
fill in the insufficient areas with urethane foam. The following illustration
shows the areas for one side, but the
foamed material must be applied equally to both the left and r ...
Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen
while the vehicle is in motion, causing the tire to come off.
2 Install the tire and loosely tighten each wheel nut by hand by approximately
the sa ...

