Toyota Corolla (E120): Side airbag sensor assy (lh) malfunction

Dtc b1141/33 side airbag sensor assy (lh) malfunction

Share this page:

Other materials:

Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

Inspection
1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...

If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s battery is discharged. You can also call your Toyota dealer or a qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your vehicle by fo ...