Toyota Corolla (E170): Deleting call histories

Select “Delete Call History” using 1 Select “Outgoing Calls” using .. ● Deleting outgoing call history 1 Select “Outgoing Calls” using 2 Select the desired phone number using.

2 Select the desired phone number using (YES). and press To delete all outgoing call history data, press (YES).

To delete all outgoing call history data, press (YES). (ALL) and then press ● Deleting incoming call history (YES).

● Deleting incoming call history 1 Select “Incoming calls” using 2 Select the desired phone number using.

2 Select the desired phone number using (YES).and press To delete all incoming call history data, press (YES).

To delete all incoming call history data, press (YES). (ALL) and then press ● Deleting missed call history (YES).

● Deleting missed call history 1 Select “Missed calls” using 2 Select the desired phone number using.

2 Select the desired phone number using (YES). and press To delete all missed call history data, press (ALL) and then press (YES).

To delete all missed call history data, press (ALL) and then press ● Deleting a number from all call histories (Outgoing calls, Incoming calls and (YES).

● Deleting a number from all call histories (Outgoing calls, Incoming calls and Missed calls)
1 Select “All Calls” using 2 Select the desired phone number using.

2 Select the desired phone number using (YES). and press To delete all of the call histories data, press (YES).

To delete all of the call histories data, press (YES). (ALL) and then press Deleting a registered phone number (YES).

    Share this page:

    Other materials:

    Manual transaxle oil
    On–vehicle inspection 1. Inspect transaxle oil Stop the vehicle on the level place.  remove the transmission filler plug and gasket.  check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug openin ...

    Malfunction in water temperature receiver gauge
    Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...

    Terminals of ecu
    1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s ...