Toyota Corolla (E170): Selecting a folder

■ Selecting a folder

Press ) or  ( () or  ( ) or ) to select the desired folder. ( ■ Selecting a folder and file from a folder list) to select the desired folder.

■ Selecting a folder and file from a folder list

1 Press A folder list will be displayed..

A folder list will be displayed.

2 Turn and press and a file. to select a folder and a file.

To return to the previous display, press ■ Returning to the first folder (BACK).

■ Returning to the first folder

Press and hold ) until you hear a beep. ( Scanning folders) until you hear a beep.

    Share this page:

    Other materials:

    Front suspension arm sub–assy lower no.1 Lh
    Replacement Hint: components: 1. Remove front wheel 2. Disconnect front stabilizer link assy lh (lh (a/t) position) 3. Disconnect front stabilizer link assy rh (lh (a/t) position) Hint: remove the rh side by the same procedures as the lh side. 4. Separate front suspension arm sub–assy lowe ...

    Inspection procedure
    Hint: when the throttle position is slightly opened (the accelerator pedal is slightly depressed) because a floor carpet is overlapped on the accelerator pedal, or if not fully releasing the accelerator pedal, etc., Dtc p505 will possibly be detected. Read freeze frame data using the ...

    Circuit description
    The crankshaft position sensor (ne signal) consists of a magnet, iron core and pickup coil. The ne signal plate (crankshaft position sensor plate) has 34 teeth and is installed on the crankshaft. The ne signal sensor generates 34 signals for each engine revolution. This sensor monitors a p ...