Toyota Corolla (E210): Emergency assistance

Share this page:

Other materials:

Inspection procedure
1 Inspect transmission wire(s2) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

Front door belt moulding assy lh
Replacement Hint: the installation procedures are the removal procedures in reverse order. Use the same procedures for the rh side and lh side. 1. Remove front armrest assy lh 2. Remove power window regulator master switch assy (w/ power window) 3. Remove front armrest base panel up ...

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...