Toyota Corolla (E120): Rear speaker assy

Replacement

Hint

: components:

1. Remove rear door opening trim rh

2. Remove rear door opening trim lh

3. Remove bench type rear seat cushion assy( or 72–8)

4. Remove rear seat back assy (fixed type rear seat)

5. Remove rear seat back assy (separated type rear seat)

6. Remove rear seat side garnish rh (fixed type rear seat)

7. Remove rear seat side garnish lh (fixed type rear seat)

8. Remove room partition board lh (separated type rear seat)

9. Remove room partition board rh (separated type rear seat)

10. Remove roof side garnish inner rh

11. Remove roof side garnish inner lh

12. Remove package tray trim panel assy

13. Remove rear speaker assy

  1. Disconnect the connector.
  2.  remove the 4 screws and rear speaker assy.

14. Install rear seat back assy (fixed type rear seat)

15. Install rear seat back assy (separated type rear seat)

16. Install bench type rear seat cushion assy

    Share this page:

    Other materials:

    If the vehicle is submerged or water on the road is rising
    This vehicle is not designed to be able to drive on roads that are deeply flooded with water. Do not drive on roads where the roads may be submerged or the water may be rising. It is dangerous to remain in the vehicle, if it is anticipated that the vehicle will be flooded or set adrift. Remain calm ...

    Circuit description
    A thermistor is built in the engine coolant temperature sensor and changes the resistance value according to the engine coolant temperature. The structure of the sensor and connection to the ecm is the same as those of the intake air temperature sensor. Hint: if the ecm detects the dtc ...

    On–vehicle inspection
    1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...