Toyota Corolla Repair Manual: Rear shock absorber with coil spring

Rear wheel alignment

Inspection 1. Inspect tire 2. Measure vehicle height Notice: before inspecting the wheel alignment, adjust the vehicle height to the specified value. 3. Inspect toe–in Toe–in: usa, canada ...

Overhaul

Hint: components: 1. Remove rear wheel 2. Remove spare wheel cover assy 3. Remove rear floor finish plate 4. Remove luggage compartment trim cover inner lh 5. Remove rear shock absorber with coi ...

Other materials:

How to register a Bluetooth® device
1 Display the “Bluetooth* Setup” screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. 2 Select “Add”. 3 When this screen is displayed, search for the device name displayed on this screen on the screen of your Bluetooth® device. For details about operating the Bluetooth® devic ...

Inspection procedure
1 Check wire harness(airbag sensor assy center – front seat inner belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat inner belt assy (lh). ...

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s si ...