Toyota Corolla (E120): Disposal

1. Dispose shock absorber assy rear lh

  1. Fully extend the shock absorber rod.
  2.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.

Caution

:

  • when drilling, chips may fly out, work carefully.
  • The gas is colorless, odorless and non–poisonous.
    Share this page:

    Other materials:

    Turn signal lever
    Operating instructions 1 Right turn 2 Lane change to the right (move the lever partway and release it) The right hand signals will flash 3 times. 3 Lane change to the left (move the lever partway and release it) The left hand signals will flash 3 times. 4 Left turn ■Turn signals can b ...

    Overhaul
    Hint: installation is in the reveres order of the removal. But the installation is indicated only when it has a point. In the rh side, work in the same procedure as in the lh side. 1. Remove rear armrest assy lh Using a screwdriver, remove the rear armrest. Hint: tape the s ...

    Wireless remote control/electronic key battery
    Replace the battery with a new one if it is depleted. As the key may be damaged if the following procedure is not performed properly, it is recommended that key battery replacement be performed by your Toyota dealer. ■If the key battery is depleted The following symptoms may occur: The smart ke ...