Toyota Corolla (E120): On–vehicle inspection

1. Install lspv gauge (sst) and bleed air

  1.  remove the bleeder plugs from the front and rear brake cylinder.
  2.  install the lspv gauge (sst), and bleed the air.

    Sst 09709–29018

2. Raise master cylinder pressure and check rear wheel cylinder pressure

Hint:

Hint

: when inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together. If the rear wheel cylinder pressure is imprper, replace the proportioning valve assy.

3. Remove lspv gauge (sst)

  1.  remove the lspv gauge (sst).

    Sst 09709–29018

  2.  install the bleeder plugs.

    Torque: 8.3 Nvm (85 Kgf·cm, 74 in.Vlbf)

4. Bleed master cylinder

 sst 09023–00100

5. Bleed brake line

6. Check for leaks

    Share this page:

    Other materials:

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...

    Rear seats
    The seatbacks of the rear seats can be folded down. Folding down the rear seatbacks 1. Move the front seats forward. 2. Stow the rear armrest. (if equipped). 3. Fold the seatback down while pushing the seatback lock release button. Each seatback may be folded separately. WARNING Observe the follo ...

    Circuit description
    The vehicle speed sensor circuit is sent to cruise control ecu assy as a vehicle speed signal. For each rotation of the shaft, the vehicle speed sensor sends a signal through the combination meter assembly to the cruise control ecu assy (see the following chart). The cruise control ecu assy ...