Toyota Corolla (E120): Replacement

1. Remove proportioning valve assy

  1. Using sst, disconnect the 5 brake tubes from the proportioning valve assy.

    Sst 09023–00100

  1. Remove the 2 bolts and proportioning valve assy from the body.

2. Install proportioning valve assy

  1. Install the proportioning valve assy with the 2 bolts.

    Torque: 5.4 Nvm (55 Kgf·cm, 48 invlbf)

  1. Using sst, connect the 5 brake tubes to the proportioning valve assy.

    Sst 09023–00100
    torque: 15.2 Nvm (155 Kgf·cm, 11 ft·lbf)

3. Fill reservoir with brake fluid

4. Bleed master cylinder

 sst 09023–00100

5. Bleed brake line

6. Check fluid level in reservoir

    Share this page:

    Other materials:

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

    Inspection procedure
    1 Check wire harness(airbag sensor assy center – front seat inner belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat inner belt assy ( ...

    On–vehicle inspection
    1. Inspect front axle hub bearing  remove the front wheel.  separate the front disc brake caliper assy .  remove the front disc.  inspect the bearing backlash. Using a dial indicator, check the backlash near the center of the axle hub. Maximum: 0.05 Mm (0. ...