General information
Displaying the device list
All devices paired with or connected to the vehicle are displayed in the device list.
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
A symbol indicates, for which function a device is used.
"Telephone"
"Additional telephone"
"Bluetooth audio"
"Apps"
"Internet hotspot"
"Apple CarPlay"
"Screen Mirroring"
Configuring the device
Functions can be activated or deactivated for paired and connected devices.
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
4. Select the desired device.
5. Select the desired setting.
If a function is assigned to a device, the function will be deactivated where appropriate for a device that is already connected and the device will be disconnected.
Disconnecting the device
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
4. Select device.
5. "Disconnect device" The device remains paired and can be connected again.
Connecting the device
A disconnected device can be reconnected.
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
4. Select device.
5. "Connect device".
The functions that were assigned to the device before disconnecting are assigned to the device when it is reconnected. The functions may be deactivated on a device already connected.
Deleting the device
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
4. Select device.
5. "Delete device".
The device is disconnected and removed from the device list.
Swapping the telephone and additional phone
If two mobile phones are connected to the vehicle, the functions of the phone and additional phone can be switched.
Via iDrive:
1. "My Vehicle".
2. "iDrive settings".
3. "Mobile devices".
4. "Settings".
5. "Swap telephone/additional tel."
Cassette tape cannot be inserted or played
Wiring diagram
Inspection procedure
1 Check for any foreign object
Check for any foreign object.
Check that no foreign object or defect is detected in the cassette
tape player of radio receiver
assembly.
Standard: no foreign object and defect detected.
2 Check cassett ...
Starting the engine
1 Continuously variable transmission: Ensure that the shift lever is in P and
depress the brake pedal.
Manual transmission: Shift the shift lever to N and depress the clutch pedal.
2 Touch the Toyota emblem side of the electronic key to the engine switch.
When the electronic key is detected, a ...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
ter ...