Toyota Corolla (E120): Lubrication

Service data

Torque specification

Torque specification

Ignition

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

    If the engine will not start
    If the engine will not start even though correct starting procedures are being followed , consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: ● There may not be sufficient f ...

    Circuit description
    The ignition switch provides circuit power and the ecm provides the circuit ground that illuminates the mil. Mil operation is checked visually: it should be illuminated when the ignition is first turned on. If the mil is off all of the time or on all of the time, use the procedure below to ...