Toyota Corolla (E210): Steering wheel
Adjustment procedure
1. Hold the steering wheel and push the lever down.
2. Adjust to the ideal position by moving the steering wheel horizontally and vertically.
After adjustment, pull the lever up to secure the steering wheel.
WARNING
■Caution while driving
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an accident, resulting in death or serious injury.
■After adjusting the steering wheel
Make sure that the steering wheel is securely locked.
Otherwise, the steering wheel may move suddenly, possibly causing an accident, and resulting in death or serious injury. Also, the horn may not sound if the steering wheel is not securely locked.
Horn
To sound the horn, press on or
close to the
mark.
Other materials:
Replacement
1. Remove battery
2. Remove battery carrier
Remove the 4 bolts and battery carrier.
3. Disconnect floor shift cable transmission control shift
Remove the nut from the control shaft lever.
disconnect the control cable from the control shaft lever.
remove the clip a ...
Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center)
Turn the ignition switch to the lock position.
disconnect the aribag sensor assy center connector.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Check wire harness(cg of dl ...
Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle
shift switches. The gear steps can then be selected by operating the “-” and “+”
paddle shift switches. By selecting gear step using paddle shift switches, you can
control engine braking forces.
1 ...