Toyota Corolla (E210): Using the storage features

Share this page:

Other materials:

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

On–vehicle inspection
1. Inspection throttle body idle speed control valve assy Notice: it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal. After check ...

Battery
Check the battery as follows. ■ Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. 1 Terminals 2 Hold-down clamp ■Before recharging When recharging, the battery produces hydrogen gas which is ...